Master Switch replaced by card another command

[BFlatman]

Hi, excellent program by the way!

I've been setting it up and adding commands. At some point, master switch was pushed lower in the order and given a normal switch type.

One of my added commands took the place of the master switch. See images attached. Any command that is in the master switch section appears not to run even if a normal duplicate is made.

After messing around I noticed this happens when you add a card by right-clicking add on the master switch card (Not sure why I did that and not on the open area below).

I've renamed it switch now and changed the original master switch to something else as when it drops down it is editable.

Just thought I'd post it if anyone else has that issue.

Thanks again for the great program!

Push2Run-bug-1.PNG (36.97 KiB) Viewed 1689 times

Push2Run-bug-1.PNG (36.97 KiB) Viewed 1689 times

[RobLatour]

Thanks, I'll take a look at the code.

However, if you exit the program and start it up again it should fix itself.

Please let me know if it did in your case.

[BFlatman]

Hi, yes it did!