This was pretty easy to figure out. If someone has already posted it, my bad, I didn't see it.
Obviously, for a Turn it down setting just change text and the parameter to -10
Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Turn it up!
Here you are welcome to share your Push2Run cards
PLEASE NOTE:
If you are downloading a Push2Run card from here or anywhere else, please inspect it carefully before running it or any software associated with it. If you don't do this you may end up with seriously unwanted results.
When sharing a card, please leave any special instructions that are required for its use. For example, if additional software is needed to enable the card, you should leave a link to the program's official webpage.
PLEASE NOTE:
If you are downloading a Push2Run card from here or anywhere else, please inspect it carefully before running it or any software associated with it. If you don't do this you may end up with seriously unwanted results.
When sharing a card, please leave any special instructions that are required for its use. For example, if additional software is needed to enable the card, you should leave a link to the program's official webpage.
Return to “Shared Push2Run cards”
Jump to
- Announcements
- ↳ Announcements
- A Viewer for Windows
- ↳ General Discussion
- ↳ Feature Requests
- ↳ Bug Reports
- ESP32 Projects
- ↳ General Discussions
- Cast
- ↳ General Discussion
- ↳ Feature requests
- ↳ Bug reports
- NotifyOnDemand
- ↳ General Discussion
- Push2Run
- ↳ General discussion
- ↳ Shared Push2Run cards
- ↳ Feature requests
- ↳ Bug reports
- SetVol
- ↳ General Discussion
- ↳ Feature Requests
- ↳ Bug Reports